Infratech WD6024 (21-2300) Dual Element 61" Bronze Patio Heater, 6000 Watts
With this patio heater you get heat output comparable to (or even greater than according to some reports) an overhead gas patio heater, with a slicker look. These patio heaters are 5' 1¼" long X 8" X 3", and are effective when mounted above 8 feet. Each heater requires a 30 amp (at 240 volt) circuit.
Infratech 304 stainless-steel heaters with bronze powder coating.
This Infratech heater can be controlled with a high-amp timer, a duplex-stack switch, or dual infinite controls economically. For further information on controls for this heater please go to our Infratech Controls section. High-End Electronic Controls, Universal Control Panel, or Home Management Panel offer the maximum versatility. Please contact us at 888-927-6456 for further information.
The Infratech 6" x 6" stock brackets provide the required 6" top clearance from combustibles (above) when the heater is pointed straight down from the ceiling. However, when the heater is tilted the clearance is reduced by 2" to 3". Choose from the optional 9" and 12" long custom brackets to provide the specified clearance for Infratech heaters that are tilted.
When Infratech's 6" x 6" patio heater mounting brackets are too wide for your mounting surface, choose the 3½" x 9" (for 4x lumber) or 1½" x 6" (for 2x lumber) optional stainless steel brackets.
- Infratech Catalog
- Infratech W- Series Installation Manual
- Infratech CAD Drawing Clearances
- Infratech Duplex Stack Switches Wiring Diagram
- Wiring Diagram: Infratech 240 Volt Infinite Regulators. This wiring diagram is for a single element (3500 watt or less at 240 volts) patio heater. Replicate this diagram for the second control and second element when used with dual-element patio heaters.
